Binding; Binding The Aircraft And St16S; Binding The Aircraft And C23; Takeoff - YUNEEC Typhoon H Plus User Manual

Binding

Binding the aircraft and ST16S

NOTICE: The aircraft and ST16S Ground Station are already bound out of factory. There is no need to
bind them. Pilot can follow the steps below if binding is needed.
STEP 1: Power on the TYPHOON H PLUS. After initialization completes, the two LEDs on rear arms will
blink blue.
STEP 2: Lift the aircraft upside down until all LEDs blink yellow quickly, and then turn the aircraft back
on straight and level ground.
STEP 3: Switch on the ST16S Ground Station. Wait a few seconds for the camera to align and all sys-
tems to be connected.
STEP 4: Tap the settings icon (
choose the Drone.
STEP 5: Tap the refresh icon (
receiver listed in the column. Wait until a tip pops up to indicate the binding is completed.

Binding the aircraft and C23

Step 1.
Switch on the ST16S followed by the TYPHOON H PLUS aircraft.
Step 2.
Tap the[ ]on the top right corner on the main interface of
ST16S, then tap the[
Step 3.
Tap the serial number of the C23 when the following window
pops up. (If multiple Yuneec UAS are used,check the ID number
on the side of each camera to assure correct camera selec-
tion/binding).
Step 4.
Using the password "1234567890" , authorize the camera and tap
"OK" to confirm.
NOTICE: If the connection process is delayed, close the pop up
window and then repeat the above steps.

Takeoff

Option 1

Press and hold the START/STOP button until the aircraft boots up.
Step back approximately 26 feet (8 meters) behind TYPHOON H
PLUS. When there is suitable GPS signal for both the ST16S Ground
Station and TYPHOON H plus, slowly raise the left-hand stick to
slightly above the center position. The aircraft will take off and climb
slowly (or raise the stick further until it does). Allow the stick to return
to the center position when the aircraft reaches the desired altitude.
) on the right top corner of the ST16S. Select the icon (
)，and then tap OK to unbind RC link. Select the corresponding
]on the switching interface.
11
) and
GPS
9
VOL
12.6V
FSK
FSK
WiFi
WIFI
CHA
POS
CHA
POS
00 : 35 : 25