Task Mode; Ccc - YUNEEC TYPHOON H3 User Manual

Task Mode

Tap the icon on the left bottom of the screen, and then you will enter task modes: CCC, Follow
me, Journey, Orbit, Team Mode.
NOTICE: When the voltage of the aircraft is lower than 30%, the TYPHOON H3 will exit TASK mode
and the functions under the TASK mode won't be activated.
CCC (Curve Cable Cam)
Curve Cable Cam allows you to create an invisible route for TYPHOON H3 to y along. Once the pilot
sets the points, TYPHOON H3 will y the set coordinates while remembering the heading.
NOTICE: The direct distance between every two waypoint should be more than 26 feet (8 meters).
Tap the CCC to enter the Curve Cable Cam function. Choose Set waypoints.
: Tap '+' to create a new point recording the
current ying position.
: Tap'-' to delete the last point created during
the ight.
NEXT : Tap the NEXT icon and Execute CCC inter-
face will be entered.
Save: Tap Save and the current route will be saved.
The name of waypoints can be de ned by the pilot.
Start: Tap Start, TYPHOON H3 will y back to way-
point 1 automatically.
[ ]: When the pilot taps the [
become [ ]and the CCC function will be paused.
When tapping it again, the [
the copter will continue the CCC function. The pilot
can exit the function by tapping[
switching ight mode.
NOTICE: when executing the CCC function，
switching the gimbal Pan mode to global mode to
control the gimbal pan by drone roll joystick and
gimbal tilt by drone pitch joystick.
]， the icon will
] will become [ ],
]icon or
20