Placement Before Takeoff; Powering On/Off - YUNEEC TYPHOON H3 User Manual

Placement before Takeoff

WARNING: Always operate the TYPHOON H3 in open areas (approximately 10000 square feet/930
square meters or more) that are free from people, vehicles, trees and other obstructions. Never y
near or above crowds, airports or buildings.
Never attempt to operate TYPHOON H3 nearby tall buildings/obstructions that do not offer a clear view
of the sky (a minimum clearance of 100°).
Be sure to place the TYPHOON H3 on a level and stable surface before powering ON the TYPHOON H3
Aircraft and the ST16S Ground Station.
IMPORTENT NOTICE: STEP BACK APPROXIMATELY 26 FEET (8 METERS)
BEHIND THE TYPHOON H3.
NOTICE: Pilots are recommended to take off the aircraft in Angle Mode. If the pilot takes off the aircraft
in Smart Mode, make sure to keep the air craft 32.8ft (10m) away from the pilot.
NOTICE: For the best performance, the 5.8GHz patch antenna should be pointed to the aircraft.

Powering ON/OFF

NOTICE: Please make sure all rmware is the latest version. Firmware and the user manual may be
downloaded from web site: www.yuneec.com. The quick start guide does not replace the user manual.
Turn on the ST16S, and then press the power button on TYPHOON H3. Release the button when the
aircraft emits a rising tone. Power on the ST16S before powering on the UAS.
NOTICE: If the Screen pops up a initialization failed on the screen. The aircraft needs to be powered on
again. To power off the aircraft, press and hold the power button until the aircraft emits a falling tune.
POWERING
ON ST16S
10
POWERING ON
TYPHOON H3