Drone Settings - YUNEEC TYPHOON H3 User Manual

IV. When the Distance between the Drone and pilot is
longer than 8m ,Push the S4 switch to the front the
drone will enter the Smart mode. There is a green S
shows on the Flight mode indicator , and the rear
motor led will also turn green.
When the Smart mode is enabled the drone will enter the Headless ight control mode.
NOTICE:
When the remote controller GPS count is less than 10, the drone will quit the Smart mode au-
NOTICE:
tomatically. If need switch on smart mode again, please wait until the remote controller GPS count is
more than 10 then slide the Flight mode switch to right again to enable the Smart mode.

Drone Settings

1. Turn on the aircraft and the remote control and wait
for the two to be connected.
2. Click the settings button[ ].
3.Select the aircraft setting switch to enter the aircraft
setting page
4.Page introduction
I. Return setting
1. Setting of return location
1) Dynamic Home: after selecting the dynamic return point, the aircraft will automatically return to the
home point based on the position of the remote control when the return key is switched on;
2) Home: select home point to return, the aircraft will take the take-off point as the home point for au-
tomatic return.
2. Setup method
Click the circle in front of the dynamic home or home to set. After setting, the remote control screen
will pop up green √, indicating that the setting is successful.
3. Return Height setting
Directly slide the return height setting slider to set the return height. Once the hand leaves the screen,
the setting is completed. After the setting, the remote control screen will pop up a green √, indicating
that the setting is successful.
18