General Settings - YUNEEC TYPHOON H3 User Manual

III. Aux (B2) key user custom function
Users can customize the function of the key
1. None, there will be no change in settings after
pressing.
2. Photo mode: click the circle in front of photo mode
to de ne the function of this key to the switch func-
tion of photo mode. After setting, when the camera is
in the photographing mode, press the aux (B2) key
once, the camera's photographing mode will switch
to the photographing mode once according to the se-
quence of single, burst, interval, AEB and panoramic
until all the photographing modes are switched, and
then start again from the single;
3. Exposure mode, click the circle in front of exposure mode, and de ne the function key to the expo-
sure mode switching function. After setting, press the aux (B2) key once, and the camera's exposure
mode will switch one exposure mode in the order of auto, manual, ISO priority and shutter priority
until all exposure modes are switched, and then start again automatically.

General settings

I. Turn on the aircraft and the remote control and wait for the two to be connected.
II. Click the settings button
III. Open the general setting switch to enter the
general setting page
IV. Interface introduction
1. Units
Users can switch between metric and imperial units. Click the circle in front of metric or imperial to
complete the setting of units
26