Polaris MATRIX INDY VR1 Series Owner's Manual page 35

IGNITION SWITCH
OFF Vehicle / Display power off
RUN Vehicle / Display power on
START Activates starter motor (if
equipped)
The ignition switch has three positions: OFF, RUN, and START.
If equipped with electric start, turn the key to START to crank the engine. When
the key is released, it automatically returns to the RUN position.
If the key remains in the RUN position after using the engine stop switch to
stop the engine, the 7S Display will remain active. The screen will turn off after
several minutes of inactivity, but if a battery is installed, the display will
continue to draw a small amount of current from the battery until the key is
turned off. This feature is useful for accessing Ride Command without starting
the engine, but turn the key off when the display is not in use.
The 7S Display is not dependent on a battery while the engine is running. This
allows the 7S to remain fully powered and retain GPS lock during a successful
PERC event (forward/reverse transition). When the engine is shut off, the
For vehicles equipped with a battery, the 7S Display will remain fully powered
(battery installed) for 60 seconds when the key remains in the RUN position
after Engine Stop Switch is depressed. The display will power off automatically
NOTICE
display will immediately power down.
after 10 minutes of inactivity.
FEATURES
33