Polaris MATRIX INDY VR1 Series Owner's Manual page 164

MAINTENANCE
4. Install the coolant bottle cap to the first lock. Do not tighten to the fully seated
position.
5. Lock the parking brake.
6. Start the engine and allow it to run at a fast idle for several minutes, until the
heaters are warm to the touch.
Keep the coolant level in the coolant bottle at or near the COLD FILL mark
when engine is running. The engine may suck the coolant down quickly which
my require coolant to be added a few times to stabilize the coolant level.
7. When all heater extrusions are warm to the touch, stop the engine.
8. Allow the engine and cooling system to cool.
9. Fill the coolant bottle to the COLD FILL mark. Reinstall the bottle cap
securely.
10. Open the side panels and reinstall the hood. Close the side panels.
EXHAUST SYSTEM
Check the exhaust system for wear or damage at approximately 2000 miles
(3200 km). Always allow the engine and exhaust system to cool completely
before inspecting.
Hot exhaust system parts can cause burns. Allow adequate time for the
exhaust system to cool. Never perform this procedure with the engine running.
1. Open the side panels and remove the hood.
2. Inspect the muffler and pipes for cracks or damage.
3. Check for weak or missing retaining springs or damper/support grommets.
4. Check for loose clamps on the pipe covers.
5. Reinstall the hood and side panels.
DRIVE CHAIN TENSION
Check drive chain tension weekly and before each long trip.
162
CAUTION
WARNING