Polaris MATRIX INDY VR1 Series Owner's Manual page 159

MAINTENANCE
SIDE PANEL AND HOOD
CAUTION
The hood and side panels of the snowmobile protect the operator from moving
parts. Never operate a snowmobile with the hood or side panels open or
removed. Always ensure that the hood and side panels are securely in place
before starting the engine
SIDE PANELS
To open a side panel, rotate the three 1/
4-turn fasteners on the outer edges of
the side panel. Release the side panel
strap at the lower edge of the panel. To
remove an open side panel, pull the
panel outward to release the tabs at the
lower edge of the panel.
HOOD
To remove the hood, do the following:
1. Remove the left and right side panels.
q
2. Rotate the 1/4 turn fasteners at the rear corners if the hood.
w
3. Disconnect the hood wire harness connector .
4. Remove the hood assembly from the vehicle.
NOTE
Store the hood in a position that will not damage the brake cooler duct.
157