Operation - Polaris MATRIX INDY VR1 Series Owner's Manual

OPERATION

STARTING THE ENGINE
Engaging the starter when the engine is running WILL result in serious engine
damage, especially if the engine is in reverse. Never engage the starter when
1. Turn the key to the ON position.
2. Pull the engine stop switch up to the RUN position.
3. If equipped with electric start, turn the key to START to crank the engine.
Release the key to the ON position when the engine starts.
4. If not equipped with electric start, grasp the starter handle and pull slowly
until the recoil engages; then pull abruptly to crank the engine.
Don't pull the starter rope to the fully extended position and don't allow it to
snap back into the housing. Damage may result.
5. If the engine does not start after several attempts, slightly depress the
throttle no more than 1/4 inch (2.54 cm) open while cranking the engine.
When the engine starts, immediately release the throttle.
To avoid injury and/or engine damage, do not operate the electric starter or
Operating the vehicle immediately after cold starting could cause engine
damage. Allow the engine to warm up for several minutes before operating the
vehicle. If cold drive-away is attempted, the engine RPM may stumble slightly
IMPORTANT
the engine is running.
pull-rope starter while the engine is running.
to protect the engine.
TIP
CAUTION
NOTICE
OPERATION
133