Polaris MATRIX INDY VR1 Series Owner's Manual page 185

BATTERY CHARGING
To ensure your battery maintains its level of charge, the battery should be
connected to a battery tender/trickle charger using the battery tender port
1. Check the battery voltage with a
voltmeter or multimeter. A fully
charged battery will register 12.8 V
or higher.
2. If the voltage is less than 12.8 volts,
recharge the battery at 1.2 amps or
less until the battery voltage is 12.8
or greater using the battery tender
q
port .
When using an automatic charger, refer to the charger manufacturer's
instructions for recharging. When using a constant current charger, use the
An overheated battery may explode, causing severe injury or death. Always
watch charging times carefully. Stop charging if the battery becomes very
warm to the touch. Allow it to cool before resuming charging.
Always verify battery condition before and 1-2 hours after the end of charging.
RESTRICTION
following guidelines for recharging.
WARNING
TIP
MAINTENANCE
q
.
183