Polaris MATRIX INDY VR1 Series Owner's Manual page 144

OPERATION
Operating the snowmobile without adequate engine lubrication can result in
serious engine damage. Always check the oil level when refueling. Add oil as
The oil bottle cap is vented to allow proper oil flow. Your POLARIS dealer can
assist with recommended replacement parts.
THROTTLE LEVER
An improperly functioning throttle lever may cause erratic snowmobile behavior
and loss of control, which could result in serious injury or death. If the throttle
lever does not work properly, DO NOT start the engine.
If the engine stops abruptly when the throttle lever is released:
1. Turn the ignition switch to OFF.
2. Visually inspect the throttle cable and carburetor/throttle body to determine
what caused the safety switch to activate.
3. Test the throttle lever by compressing and releasing it several times. The
lever and cable must return to the idle position quickly and completely.
4. If the throttle lever operates properly, turn the ignition switch on and go
through normal starting procedures.
5. If the engine doesn't start, your authorized POLARIS dealer can perform this
service.
Excessive freeplay in the throttle cable may cause the safety switch to activate,
preventing the engine from starting. If this occurs, return the snowmobile to an
authorized POLARIS dealer for service.
If an emergency exists and it's necessary to start the engine, the throttle safety
switch and engine stop switch may be disconnected from the wire harness.
When these switches are disconnected, the ignition key switch must be used to
shut off the engine. DO NOT continue to operate the snowmobile with the throttle
safety switch disconnected. Return the snowmobile to an authorized POLARIS
dealer for service as soon as possible.
142
NOTICE
needed.
WARNING