Polaris MATRIX INDY VR1 Series Owner's Manual page 165

1. Remove the side panels.
2. Rotate the driven clutch counter-clockwise to move all chain slack to the
tensioner side. Lock the brake lever lock, or have an assistant hold the brake
lever firmly.
3. Loosen the adjuster bolt jam nut
4. Finger tighten the adjuster bolt
then back off 1/4 turn.
5. Tighten the jam nut while holding the adjuster bolt.
6. Reinstall the side panels.
7. Release the brake lever lock.
BRAKES
HYDRAULIC BRAKE INSPECTION
Inspect the brake lever reserve before each use of the snowmobile. See .
Brake pads must be replaced when the brake pad material becomes thinner
than the backing plate (approximately 1/16 inch or 1.5 mm). A kit is available for
replacing brake pads. Your POLARIS dealer can assist.
q
.
w
until it can no longer be adjusted by hand,
TORQUE
Jam Nut
21 ft-lbs (28 N·m)
MAINTENANCE
163