Polaris MATRIX INDY VR1 Series Owner's Manual page 63

Do not stop the engine if you want to view the active code (failure code). Active
codes cannot be retrieved if power is interrupted to the instrument cluster. The
codes will become inactive codes if power is interrupted. Inactive codes are
stored in the history of the unit. Please see your POLARIS dealer can help
retrieve inactive codes.
Use the following procedure to view active codes.
1. Do not stop the engine.
2. Press and hold the center
Options Menu.
3. Press and release the MODE button until DIAGCODE appears in the
information display area. The Diagnostic display mode will appear in the
Options Menu if there is an active trouble code.
When the diagnostic mode is displayed, the check engine warning indicator will
4. A set of two numbers will appear in the display.
• The 2-6 digit suspect parameter number (SPN) in the information display
area indicates which component is generating the fault code.
• The 1-2 digit failure mode indicator (FMI) number in the odometer area
indicates the fault mode, such as open or short circuit.
5. More than one fault may be active. Press and hold the SET button or SET
switch for two seconds to toggle to the next active code. Repeat until all
codes are retrieved.
6. See Diagnostic Trouble Codes for code definitions and failure descriptions.
FUEL TYPE SELECTION
When using the recommended 91 non-
ethanol gasoline, always select the 91
NON-ETHANOL setting. When using
ethanol, MTBE, or other forms of
oxygenated gasoline, the fuel type must
be changed to NON-PREMIUM/
ETHANOL in the gauge.
button on the instrument cluster to enter the
TIP
begin to flash.
FEATURES
61