Id Scribe And Software Installation; Initial Setup - Thermo Scientific ID Scribe User Manual

Initial Setup

Thermo Scientific
Chapter 1
ID Scribe and Software
Installation
This chapter shows you how to set-up the ID Scribe and the necessary
software.
If an ID Scribe representative delivered your machine, your ID Scribe
unit and software should have already been set up. At the end of this
chapter, the ID Scribe should respond to the software.
Open the box and place the ID Scribe on your benchtop. Any open
space 45cm x 45cm x 45cm (18" x 18" x 18") in size and close to a
computer and a power outlet will be suitable for the ID Scribe.
Make sure your ID Scribe package has the following accessories (see
Fig. 1-1):
the ID Scribe software CD

the USB software CD

a USB cable

a power supply with cable

pens for ID Scribe

metal stops for pens

user manual

rack lifter/base

Connect the appropriate plug for your region into the power supply.
Plug the power supply cable into your wall outlet. Insert the jack end of
the power supply into the power adapter on the back of the ID Scribe
(see Fig. 1-1). Turn on the power switch. You will see a green LED
light up the front panel of the ID Scribe. The ID Scribe should
immediately "home" itself.
ID Scribe User Manual 1-1