Figure 2-4: Placing Rack And Spacer Onto Pins; Figure 2-5: Top View Of Racks Onto Pins - Thermo Scientific ID Scribe User Manual

Printing Labware
How to Load Labware
Once the ID Scribe is in the rest position, you can load the filled rack of
tubes into the ID Scribe. Line up the hole on the left side of the rack
with the left post on the base of the printing area. Push the rack down
while at the same time line up the slot on the right side of the rack with
the slightly smaller post on the right side of the base (Figs 2.4 and 2.5).
There is only one proper way to load the rack, so you cannot put it in
backwards.
Figure 2–4. Placing rack and spacer onto pins
Figure 2–5. Top view of racks onto pins
Thermo Scientific ID Scribe User Manual 2-3