Table of Contents
Advertisement
MOUNTING
Step 2: Mounting the lining
Step 3: Mounting the magnetic system
Check air gap X.
Further information on the air gap which becomes larger as a result of wear can be
found in section
26
Notes to the socket head screws!
•
To attach the magnetic system, we recommend using socket head screws
of property class 8.8. Recommended tighening torques:
M4
M5
3.0 Nm
5.9 Nm
•
With a brake construction in degree of protection IP65 (e.g. type 28.G10 /
G20, G1W / G2W) use additionally sealing washers (e.g. DIN 7603 form A)
or USIT sealing washers under the socket head screws!
=> „9.2.2 Check air
Slide the lining (3) onto the hub.
While doing so, be careful not to damage
the lining by misaligned or tilted position-
ing.
The lining must be easily movable on the
hub!
Slide the fully assembled magnetic sys-
tem (1) over the hub and the lining. While
doing so, make sure that the lining is eas-
ily movable
Use three socket head screws to fasten
the magnetic system. Observe the follow-
ing notes to the socket head screws!
M6
M8
10.1 Nm
24.6 Nm
gap".
M10
48 Nm
Advertisement
Table of Contents
