Insulet Omnipod Dash User Manual page 149

11 Taking Care of Your PDM and Pod
4. If a battery is in place, put your fingernail in the slot just below the battery
on the right-hand side and lift out the battery.
5. Orientate the new battery so the three gold tabs on the battery line up with
the three gold pins in the battery compartment. The "-" and "+" signs on the
battery label should face you.
Caution: Do not remove the label from the
battery.
Caution: Be careful not to damage any
of the small metal parts inside the battery
compartment.
6. Slide the battery into place. Gently push the
bottom of the battery to fit it into place.
7. To replace the back cover of the PDM:
a. Line up the cover' s edge along the side with the Sound/vibrate and Power
buttons. Press down on this side first.
b. Press down along the back cover until the cover has clicked into place.
The PDM is now ready to use. If this is a new PDM, see "Initial PDM Setup" on
page 21 for instructions on entering your settings.
Note: If you replaced the battery in your current PDM, you must reset the time
and date (see "Date and time and language" on page 95). Your history records
and personal settings will be saved.
132
Effective Date: 27SEP2019, ECO-000240