Section 7; Sleep Mode And Power Save Setting - banks PowerPDA 61100 Owner's Manual With Installation Instructions

Section 7

SLEEP MODE AND POWER SAVE SETTING

'Sleep Mode' is a non-adjustable
feature that is part of the Banks
PowerPDA application. The Banks
PowerPDA is designed, when in the
System Monitor screen, to initiate
'Sleep Mode' when the vehicle is
turned off or when communication is
lost. After communication is lost or
the ignition is switched off the Banks
PowerPDA will go into 'Sleep Mode'
in approximately 10 seconds. When in
'Sleep Mode' there will be a dimly lit
'Banks' screensaver in the background.
(See Figure 32) The Banks PowerPDA
will wake from 'Sleep Mode' when the
ignition is switched on or the Banks
PowerPDA regains communication. To
manually wake the Banks PowerPDA
from Sleep Mode, press the center
button on the 5-way navigator.
The Tungsten E2 also has a user
selectable 'power save' feature that
can be programmed by the user.
Note: The System Monitor screen
'Sleep Mode' is not affected by the
Tungsten E2 'power save' settings.
Figure 32
22
96803 v.3.0
Figure 33
Figure 34
1.
From the Tungsten E2 Home Screen
('Home' key), scroll down and locate
the 'Prefs' icon.
2.
Touch the 'Prefs' icon. (See Figure
33).
3.
Touch the button labeled 'Power' to
enter the edit page. (See Figure 34).
4.
Touch the button labeled 'Auto-off
after'. (See Figure 35)