On Screen Alerts; Section 11 - banks PowerPDA 61100 Owner's Manual With Installation Instructions

Section 10

ON SCREEN ALERTS

The 'On Screen Alert' menu allows
you to configure the volume control
for alarms and the corresponding
parameter to be monitored. The
available alerts icons can be seen in
Figure 43.
NOTE: In the event an alert set point
is reached an audible alarm will sound
off and the Status Indicator will display
an icon relative to the associated alert.
(See Figure 46). The alarm will turn
off once the associated parameter is
below its alert set-point. The Status
Indicator will then return to 'OK'.
1.
Press the center button on the
5-way navigator to take you to the
System Menu screen.
2.
Next, touch the 'On Screen Alerts'
button.
3.
On the 'Set Volume for Alerts'
screen, touch the desired sound level
to set the alarm level. (See Figure 44)
4.
Touch the 'Next' button to move to
the 'On Screen Alerts' screen. (Figure
45).
This selection allows you to set the
Figure 43
EXHAUST GAS TEMP
ENGINE COOLANT TEMP
ENGINE OIL TEMP
TRANSMISSION TEMP
OTTOMIND6 TUNER FAULT
value at which the alert will occur
based on exhaust gas temperature.
The selection range is 1100˚ to 1700˚.
The default value is 1450˚.
Note: This is an alert only. The
OttoMind6 is calibrated to begin
defueling when 1350˚ is reached,
regardless of the Alert Setting.
Screen 1 of the 'On Screen Alerts'
menu edits the 'Exhaust Gas
Temperature Alert Set Point'.
5.
Touch the 'Increase' button to
increase the temperature set point.
6.
Touch the 'Decrease' button to
decrease the temperature set point.
The increments are set at 25 degrees.
7.
Touch the 'Save' button to save the
setting.
8.
Touch the 'Next' button to edit
the next parameter. Follow the
same procedure listed above for the
remaining alerts.
9.
Touch the 'Done' button to return
to the System Menu.
10.
Touch the 'Back' button to return
to the 'System Monitor' screen.
-END, SECTION 10-
Figure 44
27
96803 v.3.0