Table of Contents
Advertisement
Figure 12 Chevy/GMC
6-pin connector on the Banks OBD II
interface cable to the 6-pin connector
on the OttoMind6 Tuner harness.
9.
Finally, unclip the dashboard
panel, starting with the lower right
hand corner. (See Figures 11-14) Pry
and unclip as needed to gain enough
clearance to route the RJ12 cable
(simular to telephone connector)
behind the panel, along its lower edge.
10.
Locate the RJ12 connector portion
on the Banks interface cable and pull
enough cable through to reach the
bottom of the Docking Station.
11.
Connect the RJ12 cable into the
left-most receptacle on the bottom of
the Docking Station.
Warning: The charging cable on
the Docking Station is designed
to supply a constant low-voltage
power source (+5VDC) to the Banks
PowerPDA and is "live" as long
as the system's OBD II interface
cable is completely installed and
the RJ12 connector is plugged into
the Docking Station. Although
10
96803 v.3.0
this charging cable is short and its
circuitry is fuse-protected, the user
is expected to take appropriate
measures to prevent small children
and/or pets from contact with any
part of this system.
12.
Refit the dash panel by carefully
snapping it back into place. Tuck any
excess cable behind it for a clean
appearance.
13.
Your Docking Station is now
installed and is ready for the
Banks PowerPDA. Install the Banks
PowerPDA into the Docking Station.
Be sure the Banks PowerPDA is
completely seated in the Docking
Station against the lower support
bracket.
14.
Plug the Docking Station's
charging cable into the charging
receptacle on the lower edge of the
Banks PowerPDA.
NOTE: There may be a snug fit when
installing the Banks PowerPDA into the
Docking Station. Take care not to force
this process.
Advertisement
Table of Contents
