banks PowerPDA 61100 Owner's Manual With Installation Instructions page 16

Ford ('03-04)
25.
Locate the self-drilling screw
supplied in your kit.
26.
Install the screw through the
large access hole in the bottom of the
Docking Station. Doing this will put
a permanent hole in the dashboard
panel. Be certain of the location
of the Docking Station before
installing the screw.
Note: The Docking Station must
be connected to the previously
installed Banks PowerPDA-
compatible OttoMind6 tuner via an
RJ12 cable (simular to telephone
connector). If your OttoMind6
tuner is not installed, refer to the
OttoMind6 tuner owner's manual to
install the tuner before proceeding.
27.
Remove the fuse access panel
below the steering column. It is
secured by four 1
28.
Remove the smaller dash panel
immediately to the right as shown in
Figures 23 and 24. Unclip it by pulling
in the area shown in the picture.
29.
Locate the RJ12 cable from
your OttoMind6 Wiring harness and
route it to the bottom of the Docking
Figure 22 Ford ('03-'04)
16
96803 v.3.0
⁄ -turn plastic screws.
4
Station behind the panels you've just
removed.
30.
Connect the RJ12 cable to the
left-most receptacle on the bottom of
the Docking Station.
Warning: The charging cable on
the Docking Station is designed
to supply a constant low-voltage
power source (+5VDC) to the Banks
PowerPDA and is "live" as long
as the system's OBD II interface
cable is completely installed and
the RJ12 connector is plugged into
the Docking Station. Although
this charging cable is short and its
circuitry is fuse-protected, the user
is expected to take appropriate
measures to prevent small children
and/or pets from contact with any
part of this system.
31.
Refit the dash panel by carefully
snapping it back into place. Refit
the fuse access panel using the four
fasteners removed earlier. Tuck any
excess cable behind the panels for a
clean appearance.
32.
Your Docking Station is now
installed and is ready for the
Banks PowerPDA. Install the Banks
PowerPDA into the Docking Station.