Table of Contents
Advertisement
Dodge
Note: The Docking Station must
be connected to the previously
installed Banks PowerPDA-compatible
OttoMind6 tuner via an RJ12 cable
(simular to telephone connector). If
your OttoMind6 tuner is not installed,
refer to the OttoMind6 tuner owner's
manual to install the tuner before
proceeding.
15.
To route the RJ12 cable
connecting the Docking Station to the
OttoMind6 (see OttoMind6 owners
manual for details), you will need to
unclip the knee panel (See Figure
16) Pry and unclip as needed to gain
enough clearance to route the cable
behind the panel.
16.
Locate the RJ12 cable on your
OttoMind6 wiring harness and pull
enough cable through to reach the
bottom of the Docking Station.
17.
Locate and remove the screw
in the dash panel above the hook as
shown in Figure 17.
18.
Remove the dash panel by gently
pulling and unclipping it as needed.
(See Figure 18).
Figure 15 Dodge
12
96803 v.3.0
19.
Guide the RJ12 cable through the
clearance between the removed panel
and the dash as shown in Figure 19.
20.
Looking at the back of the dash
panel, locate the screw for the dash
plate as shown in Figure 20. This
panel may be blank, or contain the
airbag deactivation switch. Remove
the screw and the plate.
21.
Route the RJ12 cable through
the opening and connect it to the left
most receptacle on the bottom of the
Docking Station. Replace the dash
plate and screw.
Warning: The charging cable on
the Docking Station is designed
to supply a constant low-voltage
power source (+5VDC) to the Banks
PowerPDA and is "live" as long
as the system's OBD II interface
cable is completely installed and
the RJ12 connector is plugged into
the Docking Station. Although
this charging cable is short and its
circuitry is fuse-protected, the user
is expected to take appropriate
measures to prevent small children
and/or pets from contact with any
part of this system.
Advertisement
Table of Contents
