Section 1; Installation Of Wiring Harness And - banks six-gun Owner's Manual

Banks iQ System .....................61152
Banks Monster
®
'03 F-250/350 Pickup
Ext cab, short bed .......................48764
'04-07 F-250/350 Pickup
Ext cab, short bed .......................48784
'03 F-250/350 Pickup
Ext cab, long bed ........................48766
'04-07 F-250/350 Pickup
Ext cab, long bed ........................48786
'03 F-250/350 Pickup
crew cab, short bed ...................48765
'04-07 F-250/350 Pickup
crew cab, short bed ...................48785
'03 F-250/350 Pickup
crew cab, long bed .....................48767
'04-07 F-250/350 Pickup
crew cab, long bed ....................48787
'03 Excursion ...............................48768
'04-07 Excursion .........................48788

Section 1

INSTALLATION OF WIRING HARNESS & CONNECTIONS FOR SIx-GUN/
ECONOMIND DIESEL TUNER
If Six-Gun has been previously
installed, skip to Section 2.
1.
Disconnect the battery ground
cables from each of the batteries.
Secure the cables so that they do not
come in contact with the battery posts
during the installation.
2.
Remove the (+) battery cable from
the driver side battery.
3.
Remove the driver side plastic
battery cover, as shown in Figure 2.
This is accomplished by depressing a
tab at the front and rear of the cover.
Be careful not to damage the cover, as
it will be re-installed.
8
96808 v.14 .0
Exhaust:
Additional Equipment:
Technicooler ('03-04) .....................25974
®
Technicooler ('05-07) .....................25975
®
Gauge Assembly,
Boost and Pyro ...........................64507
Thermocouple ............................63055
4.
Remove the driver side battery hold
down clamp (8mm socket). Remove
the driver side battery.
WARNING: When lifting a battery,
excessive pressure on the end
walls could cause acid to spew
through the vent caps, resulting in
personal injury. Lift with a battery
carrier or with hands on opposite
corners. Failure to follow these
instructions may result in personal
injury.