Table of Contents
Advertisement
Ford ('05-'06)
Note: The Docking Station must
be connected to the previously
installed Banks PowerPDA-compatible
OttoMind6 tuner via an RJ12 cable. If
your OttoMind6 tuner is not installed,
refer to the OttoMind6 tuner owner's
manual to install the tuner before
proceeding.
34.
Remove the fuse access panel
below the steering column by pulling
on it with the handles as shown in
Figure 26.
35.
Remove the smaller dash panel
immediately to the right as shown in
Figure 27. Unclip it by pulling in the
area shown in the picture.
36.
Locate the RJ12 cable from
your OttoMind6 Wiring harness and
route it to the bottom of the Docking
Station behind the panels you've just
removed.
37.
Connect the RJ12cable to the left-
most receptacle on the bottom of the
Docking Station.
Warning: The charging cable on
the Docking Station is designed
to supply a constant low-voltage
power source (+5VDC) to the Banks
PowerPDA and is "live" as long
as the system's OBD II interface
cable is completely installed and
the RJ12 connector is plugged into
the Docking Station. Although
this charging cable is short and its
circuitry is fuse-protected, the user
is expected to take appropriate
measures to prevent small children
and/or pets from contact with any
part of this system.
38.
Refit the dash panel by carefully
snapping it back into place. Refit the
fuse access panel and tuck any excess
cable behind the panels for a clean
appearance.
18
96803 v.3.0
38.
Your Docking Station is now
installed and is ready for the
Banks PowerPDA. Install the Banks
PowerPDA into the Docking Station.
Be sure the Banks PowerPDA is
completely seated in the Docking
Station against the lower support
bracket.
40.
Plug the Docking Station's
charging cable into the charging
receptacle on the lower edge of the
Banks PowerPDA.
NOTE: There may be a snug fit when
installing the Banks PowerPDA into the
Docking Station. Take care not to force
this process.
-END, SECTION 3-
Figure 25 Ford ('05-'06)
Advertisement
Table of Contents
