Programming; Operation - NEC DS1000 Release Notes

DS1000 02.10.09 Release Notes
New Features in 02.10.09

Programming

Operation

2 N 02.10.09
Description
Busy tone
Audible ring tone (ring-
back)
Stutter dial tone
0401-Auto Redial Retry Timer
Use the option to set the interval between Auto Redial callout attempts. The default setting is 30
seconds (30).
0401-Auto Redial Busy Timer
This option sets how long the system waits for busy tone when processing an Auto Redial callout
attempt. The interval is measured from the last digit dialed to the receipt of busy tone. If the system
doesn't receive busy tone within this interval, it assumes that the call went through and cancels
Auto Redial. The default setting is 6 seconds.
To enable Auto Redial:
1. Place an outside call and receive busy tone + Press AUTO REDIAL (ALND) soft key.
OR
2. Press a line key + Press AUTO REDIAL (ALND) soft key.
The system enables Auto Redial for the last outside call you dialed.
3. At a 22-Button or 34-Button Display, you see:
At a Super Display, you see:
The display shows the interval between callout attempts (e.g., 30 seconds), as well as
how many times redial has occurred (e.g., 1 of 15).
Your SPK key winks on to indicate your phone is in the Auto Redial mode.
4. The system periodically redials the call, up to 15 times, or until you:
G
Place or answer another outside call.
G
Receive an Intercom voice announcement or answer an Intercom call by lifting the hand-
set or pressing SPK .
Call Progress Tones
Frequencies
480 Hz + 620 Hz
440 Hz + 880 Hz
350 Hz + 440 Hz
Rate
500 mS on, 500 mS off
(+ 50 mS)
800mS to 1.2 sec on, 2.7
sec to 3.3 sec off
800 mS to 1.2 sec on,
800mS to 1.2 sec off
DS1000 Release Notes