Operation - NEC DS1000 Release Notes

DS1000 02.10.09 Release Notes
New Features in 02.10.09

Operation

18 N 02.10.09
*. The PIN code is used for both Extension Locking and Walking Class of Service. By default, there
are no PIN codes entered. In addition:
G
An extension user can dial ICM + ##6 to enter or change their PIN number.
G
The operator can dial ICM + ##3 to erase a co-worker's PIN number and unlock their extension.
To enter 1807-PIN Code data:
G
When you see PIN CODE? , press HOLD to enter the data entry mode.
G
While in the data entry mode:
- Vol Up scrolls right.
- Vol Down scrolls left.
- LND backspaces over (erases) the last entered digit.
- CLEAR + HOLD erases the current entry.
- CHECK restores the previous entry.
- HOLD registers the entry and advances to the next prompt.
- CONF exists the program.
To enable Walking Class of Service at an extension:
When using the procedures that follow to enter a PIN number or extension number:
G
CLEAR erases your entire entry.
G
LND backspaces over (erases) the last digit entered.
1. Press ICM .
2. Dial ##0 .
At a 22- or 34-Button Display Telephone, you see:
At a Super Display Telephone, you see:
If your extension does not have a PIN code already entered, skip to step 4.
3. Enter your own extension number + HOLD .
At a 22- or 34-Button Display Telephone, you see:
DS1000 Release Notes