Overheating Protection - Silvercrest SFG 1900 A1 Operating Instructions Manual

Never move the deep fryer 9 while it is
still hot!
1. Press the button for adjusting the han-
dle 5 on the frying basket 3 and fold the
handle 6 out.
2. Fill the food to be fried into the frying bas-
ket 3. The frying basket 3 must not be
filled above the MAX 2 marking.
3. When the temperature control light 11
is lit, press the button for opening the
lid 8, and open the lid 1.
4. Now carefully lower the frying basket
into 3 the oil. The metal bracket of the
handle 4 must rest on the edge of the
oil container 7.
5. Close the lid 1. It must click into place
firmly.
6. The food cooks very quickly when being
fried. Please observe the recommended
frying times as precisely as possible.
7. When the food to be fried is ready,
press the button for opening the lid 8,
and open the lid 1.
8. Figure A: take the frying basket 3 out
of the oil/fat and hang it to drip with
the metal bracket of the handle 4 on the
front edge of the oil container 7.
9. When the fat has dripped off, put the
food into a bowl or similar.
10.For additional frying processes, another
temperature must be set, if applicable.
11.Prior to each frying process, the device
should be given time to heat up until the
temperature control light 11 is lit again.
32 GB
12.When you finish frying, switch the tem-
perature control 14 to the lowest temper-
ature setting.
13.Switch the on/off switch O/I 12 of the de-
vice to O to switch the device off. The
operation control light 10 and the tem-
perature control light 11 will go out.
14.Pull out the mains plug 18 and allow
the device to cool.

7.5 Overheating protection

DANGER of burns!
Let the deep fryer 9 cool down for ap-
prox. 2 hours before you move, empty,
or clean it.
The fryer is equipped with an overheating
7
protection, which automatically switches the
device off in the event of overheating. In this
4
case the button Reset 16 on the underside of
the device is released.
1. Turn down the temperature and pull out
the mains plug 18.
2. Allow the device to cool down to room
temperature.
3. Press in the reset button Reset 16 on
the underside of the deep fryer 9
again.
4. Wait a few minutes before you plug the
mains plug 18 back into the mains and
set the desired temperature.
16