Overheating Protection; Cleaning - Silvercrest SEF 2300 B2 Operating Instructions Manual

Cool-zone deep fat fryer
Hide thumbs Also See for SEF 2300 B2:
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 4
B53B)ULWWHXVHB%ERRN 6HLWH  0LWWZRFK  $XJXVW   
1. Fill the food to be fried into the frying
basket|18. The basket should be filled
no more than half.
2. When the control lamp|7 goes out,
press the button|3 for opening the lid,
and lift the lid|1 off.
3. Now, carefully lower the frying bas-
ket|18 into the oil.
4. Press and hold the button|3 on the han-
dle|2 and put the lid on the oil contain-
er|14.
5. Watch the frying process through the in-
spection window|19. The food cooks
very quickly when being fried. Please
observe the recommended frying times
as precisely as possible.
6. When the fried food is ready, press the
button|3 for opening the lid, and lift the
lid|1 off.
7. Take the frying basket|18 out of the oil/
fat and hang it with the mount under the
handle|17 on the front edge of the oil
container|14 for dripping off.
8. When the fat has dripped off, put the
food into a bowl or the like.
9. For additional frying processes, another
temperature must be set, if applicable.
10.Prior to each frying process, the device
should be given time to heat up until the
temperature control lamp|7 has gone
out again.
11.When you finish frying, switch the tem-
perature controller|8 to MIN
12.Pull out the mains plug|10 and allow
the device to cool.

8.5 Overheating protection

Figure A: the fryer is equipped with an
overheating protection which ensures that
the device will automatically be switched off
in case of any overheating. In this case the
button RESET|20 is released.
1. Lower the temperature and pull out the
mains plug|10.
2. Press the button RESET|20 on the back
of the base unit|11 fully to engage it,
e.g. with a pencil.
3. Wait a few minutes before you connect
the mains plug|10 again with the mains
and set the desired temperature.

9. Cleaning

DANGER of burns!
~ Let the fryer cool down for approx.
2|hours before you move, empty, or
clean it.
DANGER! Risk of electric
shock!
~ Pull out the mains plug|10 from the wall
socket before cleaning the fryer.
WARNING!
~ Do not use any astringent or abrasive
cleaning agents.
1. Press the button|3 for releasing the lid,
and lift the lid|1 off.
2. Put the lid|1 into a sink or on a kitchen
towel.
13
GB

Advertisement

Table of Contents
loading

Table of Contents