Contents; Introduction - Nortel Communication Server 1000 Manual

.
Basic configuration

Contents

This section contains information on the following topics:
"Introduction" (page 41)
"Configuring basic capabilities" (page 44)
"Configuring call charging information" (page 53)
"Configuring Calling Line Identity" (page 53)

Introduction

Table 13 "Configuring DASS2 capabilities" (page 41)
configure basic DASS2 capabilities.
Note:
17 for DASS2 systems running on software up to and including Group
G, and systems running on software up to and including Group H. Refer
to the
Table 13
Configuring DASS2 capabilities
Step Overlay
1
LD 17 Configuration Record
Please note the difference in configuration requirements in LD
"Note about port addressing modes" (page
Action
Group G and earlier
Configure DASS2 D-channel port number for the
NT5K35 DCHI, or the NT5K75 DCHI or NT6D11AE
operating in standard mode. This is the number used
to reference the D-channel in LD 74; the value is
entered against the DCHI prompt, and is in the range
of 0-15.
Configure PRI loop number
Group H and later
Nortel Communication Server 1000
DASS2 Fundamentals
NN43001-571 04.01 4 June 2010
Copyright © 2007-2010 Nortel Networks. All Rights Reserved.
41
outlines steps to
42).