Feature Implementation; Feature Operation - Nortel Communication Server 1000 Manual

Feature implementation

Table 30
LD 74 - Modify the Digital Private Network System Signaling No.1 link data block.
Prompt Response
REQ CHG
TYPE DDLS
...
S2 (0)-1
0-n
DDSL
SIGL DA
DDCS 0-159
PRIV
(YES)
NO
aaa
- SIDE
- MWIF (STD)
ISDM
- L2_RST (YES)
NO

Feature operation

No specific operating procedures are required to use this feature.
Description
Change existing data.
Digital Private Network System Signaling No.1 link data block.
Switch 2 mode (the mode selected with the switch S2 located
on the NT5K75AA DCHI cards) where:
0 = NT5K35AA DCHI or NT5K75AA DCHI cards operating in
standard mode (default)
1 = NT5K75AA DCHI card operating in expanded mode.
DPNSS link number where:
n = 63 for NT5K35AA or NT5K75AA in standard mode (S2 = 0)
n =159 for NT5K75AA in expanded mode (S2 = 1).
DASS2 Level 2 Signaling.
Digital Trunk Channel Switch loop number.
Private link:
DPNSS1 DASS2
Side for termination where:
aaa = AETBNT for DPNSS1 or BNT for DASS2.
Message Waiting Indication.
Reset Layer 2 indication during system initialization.
NO should only be entered when using the Dual D-channel
Daughterboard (NTAG54) on a D-channel Primary Rate
Interface (NTCK43) card.
If this prompt is set to NO on an NTG011 or NT5K75 type card,
the card will be left disabled after INIT occurs.
Nortel Communication Server 1000
DASS2 Fundamentals
NN43001-571 04.01 4 June 2010
Copyright © 2007-2010 Nortel Networks. All Rights Reserved.
Feature operation 65