Nortel Communication Server 1000 Manual page 180

180 IDA status check and start-up
Table 102
DTM error messages
Code Description
DTM000 Program Identifier
DTM001 Too many characters
DTM002 Invalid character input
DTM003 Invalid command
DTM004 Wrong number of parameters
DTM005 Invalid parameter
DTM006 Invalid customer number
DTM020 Card is not configured
DTM021 Card number is not specified
DTM022 Card number is out of range
DTM023 Card is already enabled
DTM024 Card does not respond
DTM025 Loop is not a DTCS/DDCS
DTM026 DTSL/DDSL is disabled
DTM027 Signaling link is not available
DTM030 Command is not allowed
DTM040 Message input failed
DTM042 DTCS/DDCS cannot be disabled
while its DTSL/DDSL is still enabled
DTM043 Not a DTSL/DDSL
DTM047 DTCS/DDCS is disabled
DTM048 Channel is already disabled
DTM049 A previous DISI has not been
completed
DTM050 Message not defined by MSG
DTM051 Invalid byte
DTM052 Invalid channel number
Nortel Communication Server 1000
DASS2 Fundamentals
NN43001-571 04.01 4 June 2010
Copyright © 2007-2010 Nortel Networks. All Rights Reserved.
Action
Check input and re-enter
Check input and re-enter
Check input and re-enter
Check input and re-enter
Check input and re-enter
Check input and re-enter
Check input and re-enter; If DTM020
is still output, check that the DTCS
and DTSL are configured
Check input and re-enter
Check input and re-enter
Check that the card switch is enabled
and properly configured
Check input and re-enter; If DTM025
is still output, check the configuration
record
Perform STAT on DTSL; if in service
or enabled, then the far end of link is
suspect
Check that sufficient digital trunk I/O
buffers are configured
DTSL must be disabled before DTCS
is disabled
Check input and re-enter
Wait and re-enter DISI when current
one has ended
Format the message using MSG
command first
Check input and re-enter
Check input and re-enter