Nortel Communication Server 1000 Manual page 46

46 Basic configuration
Table 16
LD 17 Configure DASS2 DCHI and PRI loop number. (cont'd.)
Prompt Response
DNUM 0-15
DPNS YES
PARM YES
.......
35-1000
DTIB
DTOB 4-100
.......
CEQU YES
.......
DDCS 0-159
Table 17
LD 73 Define clock synchronization control.
Prompt Response
REQ CHG
TYPE PRI2
FEAT SYTI
PREF CK0 0-159
PREF CK1 0-159
SREF CK0 0-159
Description
The hardware I/O address of the DCHI. The switches on the
DCHI must be set to correspond to this address.
Indicates that the DCHI is being used for DASS2.
To allow changes to the system buffers.
Size of IDA trunk input buffers for entire system (determined
according to traffic).
Note: The system must be initialized to invoke changes to DTIB.
To define the number of IDA trunk output buffers per DCHI
(determined according to traffic).
Note: The system must be initialized to invoke changes to
DTOB.
To allow changes to the Common Equipment parameters.
The PRI loop number for the new DASS2 link. Enter multiples
separated with a space.
Note: PRI loop numbers may have to be even values if the
adjacent loop on the network card is programmed.
Description
Modify existing data base.
2.0 Mb/s PRI.
Digital system timers.
The primary reference loop numbers for clock controller 0.
The primary reference loop numbers for clock controller 1
The secondary reference loop numbers for clock controller 0.
Nortel Communication Server 1000
DASS2 Fundamentals
NN43001-571 04.01 4 June 2010
Copyright © 2007-2010 Nortel Networks. All Rights Reserved.