Nt5D97Ad Dual-Port Dti2/Pri2 Installation And Removal - Nortel Communication Server 1000 Manual

148 PRI installation and removal
Table 73
Steps for installing a network expansion shelf (cont'd.)
Step Action
6
Install and connect the QCAD172A power cable to the added QUD15 cooling unit
as follows:
If the added QUD15 is located below the left Network shelf, unplug the C11
connector from the QCAD111 power harness that connects to the existing left side
QUD15.
If the added QUD15 is located below the right Network shelf, unplug the C21
connector from the QCAD111 power harness instead of the C11.
•
Plug the C11 or C21 connector into the single-ended connector of the
QCAD172A power cable.
•
Plug one of the two connectors at the other end of the C11 or C21 connector
that was removed.
•
Plug the remaining connector of the QCAD172A power cable into the added
QUD15.
7
At the QCAD111 power wiring harness, untie and then connect:
•
the C17 power connection cable to the right rear Network shelf
•
the C19 power connection cable to the left rear Network shelf
8
Install PRA trunks and enter related shelf and PRI office data into switch memory.

NT5D97AD Dual-port DTI2/PRI2 installation and removal

Following is information required to install the NT5D97AD Dual-port
DTI2/PRI2 (DDP2) card.
For installation and removal procedures for the NTAG54 Downloadable
D-channel daughterboard, refer to the section
Daughterboard" (page 141)
(page
NT5D97AD circuit card locations
Each NT5D97AD card requires one slot on a shelf. NT5D97AD cards can
be placed in any card slot in the network bus.
Port definitions
Since the NT5D97AD card is a dual-card, it equips two ports; these ports
are defined in
141).
Table 74 "DDP2 loops configuration" (page
Nortel Communication Server 1000
DASS2 Fundamentals
NN43001-571 04.01 4 June 2010
Copyright © 2007-2010 Nortel Networks. All Rights Reserved.
"Installing the NTAG54
and "Removing the NTAG54 Daughterboard"
149).