Connecting The Probe To The Pm880 - GE PM880 Operations & Installation Manual

Installing the Probes (cont.)
Note: Standard moisture probes have a sintered stainless-steel
shield that protects the aluminum oxide sensor. Leave the
shield in place for maximum protection.
It is important to eliminate all leaks for safety reasons and to be
sure that measurements are not affected by ambient
contamination. GE Panametrics recommends conducting a leak
test of the sample system prior to operation.

Connecting the Probe to the PM880

Connect the probe cable to the top of the unit as shown in Figure
2-3 below.
Figure 2-3: Connection Locations
To ensure the safe operation of the PM880, you
must install and operate it as described in this
manual. In addition, be sure to follow all
applicable safety codes and regulations for
installing electrical equipment in your area.
Initial Setup
Probe Input
!WARNING!
August 2003
2-9