Specifications - Beckman Coulter Optima TLX Instruction Manual

Description

SPECIFICATIONS

*
Normally only nonconductive pollution occurs; occasionally, however, a temporary conductivity caused by condensation must be expected.
1-10
Only values with tolerances or limits are guaranteed data. Values
without tolerances are informative data, without guarantee.
Speed
Set speed . . . . . . . . . . . 5 000 to 120 000 rpm in 1 000-rpm increments
Speed control . . . . . . . . . . . . . actual rotor speed, ±50 rpm of set speed
Speed display . . . . . . . . . . . . actual rotor speed in 100-rpm increments
Time
Set time . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Time display
Manual operation . . . . . . . . . . . . . . . indicates run time remaining
Programmed operation . . . . . . . . . . . . . . . . time remaining in step
Temperature
Set temperature . . . . . . . . . . . . . . . . . . . . .
Temperature control (after equilibration). . . . . ±2°C of set temperature
Temperature display . . . . . . . . . . . . . . . . . . . . . actual rotor temperature
Ambient temperature range . . . . . . . . . . . . . . . . . . . . . . . . . 15 to 35°C
Humidity restrictions. . . . . . . . . . . . . . . . . . . . . . . . <95% (noncondensing)
Vacuum . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . below 10 microns (1.34 Pa)
Acceleration . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10 acceleration profiles—
full acceleration to set speed; or maximum acceleration
Deceleration . . . . . . . . . . . . . . . . .
without brake; or full dynamic braking from set speed
Dimensions
Width . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 73.7 cm (29 in.)
Depth . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 58.4 cm (23 in.)
Height. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 53.3 cm (21 in.)
Weight . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Ventilation clearances (sides and rear) . . . . . . . . . . . . . . . .
Finishes
Control panel . . . . . . . . . . . . . . . . . . . . . . . . . . . . coated polycarbonate
Top surface . . . . . . . . . . . . . . . . . . . . . . . . . . . . . acrylic baking enamel
Other surfaces. . . . . . . . . . . . . . . . . . . . . . . . . . . . general purpose paint
Electrical requirements
100-V instrument . . . . . . . . . . . . . . . . . . . 90–110 VAC, 12 A, 50/60 Hz
120-V instrument . . . . . . . . . . . . . . . . . . 100–130 VAC, 12 A, 50/60 Hz
220/240-V instrument . . . . . . . . . . . . . . . . . 198–254 VAC, 6 A, 50 Hz
Electrical supply . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Class I
Maximum heat dissipation into room under
steady-state conditions . . . . . . . . . . . . . . . . . . . . . .
Noise level 0.91 m (3 ft) in front of centrifuge . . . . . . . . . . . . . . . . <60 dBa
Installation (overvoltage) category . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . II
Pollution degree. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2
and 10-rpm increments at speeds below 5 000 rpm
2 to 40°C in 1° increments
9 slow rates from 0 to 5 000 rpm followed by
11 deceleration profiles—10 slow rates
from 5 000 to 0 rpm, including coasting to a stop
above 5 000 rpm
to 99 hours 59 minutes
in 0.1° increments
81 kg (178 lb)
7.6 cm (3.0 in.)
1750 Btu/hr (0.5 kW)
*