Enervista 650 Setup Software; System Requirements; Installation - GE Multilin GEK-113000T User Manual

1 GETTING STARTED

1.3ENERVISTA 650 SETUP SOFTWARE

The EnerVista 650 Setup software interface is the preferred method to edit settings and view actual values because the PC
monitor can display more information in a simple comprehensible format.
The following minimum requirements must be met for the EnerVista 650 Setup software to properly operate on a PC:
• Pentium® class or higher processor (Pentium® II 300 MHz or higher recommended)
• Windows® NT 4.0 (Service Pack 3 or higher), Windows® 2000, Windows® XP
• Internet Explorer® 5.0 or higher
• 64 MB of RAM (128 MB recommended)
• 40 MB of available space on system drive and 40 MB of available space on installation drive
• RS232C serial and/or Ethernet port for communications to the relay
After ensuring the minimum requirements for using EnerVista 650 Setup are met (see previous section), use the following
procedure to install the EnerVista 650 Setup from the GE EnerVista CD.
1. Insert the GE EnerVista CD into your CD-ROM drive.
2. Click the Install Now button and follow the installation instructions to install the no-charge EnerVista software.
3. When installation is complete, start the EnerVista Launchpad application.
4. Click the IED Setup section of the Launch Pad window.
GEK-113000T
Figure 1–8: LAUNCHPAD WINDOW
F650 Digital Bay Controller
1.3 ENERVISTA 650 SETUP SOFTWARE

1.3.1 SYSTEM REQUIREMENTS

1.3.2 INSTALLATION

1
1-11