Keyboard Operation; Parameter Numbers And / Values; Resetting Of Error Messages; Password Input - KEB COMBIVERT F5 Series Instructions For Use Manual

OPERATION OF THE CONTROL

8.2.1 Keyboard operation

8.2.1.1 Parameter numbers and / values

When COMBIVERT F5 is switched on, the display shows the value of customer param-
eter CP.1.
The function key (FUNC) changes between the parameter
value and parameter number.
With UP (▲) and DOWN (▼) the value of the parameter
number is increased/decreased with changeable parameters.
Principally during a change, parameter values are immediately accepted and stored
non-volatile. However, with some parameters it is not useful that the adjusted value is
accepted immediately. The value is accepted and stored non-volatile by pressing EN-
TER. A point is displayed behind the last digit if such a parameter is changed.
The value is accepted and stored non-volatile by pressing EN-
TER.

8.2.1.2 Resetting of error messages

If a malfunction occurs during operation, then the actual display is overwritten by the
error message. The error message in the display is reset by ENTER.
With ENTER only the error message in the display is reset. In order to reset the error
itself, the cause must be removed and a reset or a power-on-reset must be made.

8.2.1.3 Password input

The COMBIVERT is equipped with a comprehensive password protection. Depending
on the entered password the following modes are possible:
Display
CP_ro
CP_on
CP_SE
APPL
–
The permissible menu for the application is determined by the machine builder.
The password input generally occurs via parameter CP.0. The adjusted password /
menu remains also after switching off.
54
— Error —>
Mode
End customer menu (CP-Parameter) read-only
End customer menu (CP-Parameter) read/write
Service menu (like end customer menu, however with the original pa-
rameters)
Application menu (all parameters and parameter groups visible)
Drive mode (COMBIVERT can be put into operation via keyboard)
FUNC.
SPEED
STOP
START
ENTER
F/R
ENTER
F/R
STOP
START