Specification And Connection Of The Analog Inputs; Figure 6: Connection Of The Relay Output; Table 12: Specification Of The Analog Inputs An1 And An2 - KEB COMBIVERT F6 Instructions For Use Manual

ASSIGNMeNT OF THe TeRMINAL STRIP X2A
The relay output of the control card Pro is available in two different versions.
Material number of COMBIVERT xxF6Pxx-xxyx
PIN
X2A.14
X2A.13
X2A.15
Figure 6:
WARNING

2.4.5 Specification and connection of the analog inputs

Input type
Analog input 1
Analog input 2
Input values
DC voltage input
Current input
Common mode range V
Table 12:
24
Relay (y=0-3)
Name
- in preparation -
RLA NO contact
RLB NC contact
RLC Switching contact
14
R1
13 15
Fault signalling relay
Connection of the relay output
No internal protection of the relay contacts !
Welding of the relay contacts due to prohibited overload !
► Limit the current trough the contacts to 2 A, e. g. by using a fuse
type 2A gG.
► Details see safety manual.
CM
Specification of the analog inputs AN1 and AN2
Positively driven relay (y=4, 5)
(only control by safety modul)
NO contact
- not assigned -
Switching contact
14
Positively driven relay
Non-isolated differential input
X2A.17 (AN1-), X2A.18 (AN1+)
X2A.19 (AN2-), X2A.20 (AN2+)
Current/voltage switchable
±10 V
±20 mA; 4...20 mA
-12.5...17.5 V
R1
15