Prestige 2602HW Series User's Guide
21.7 Firmware Screen
Find firmware at www.zyxel.com in a file that (usually) uses the system model name with a
"*.bin" extension, e.g., "Prestige.bin". The upload process uses HTTP (Hypertext Transfer
Protocol) and may take up to two minutes. After a successful upload, the system will reboot.
See
Chapter 37 on page 365
Only use firmware for your device's specific model. Refer to the label on the bottom of your
device.
Click Firmware to open the following screen. Follow the instructions in this screen to upload
firmware to your Prestige.
Figure 124 Firmware Upgrade
The following table describes the labels in this screen.
Table 84 Firmware Upgrade
LABEL
File Path
Browse...
Upload
Reset
Note: Do not turn off the Prestige while firmware upload is in progress!
After you see the Firmware Upload in Process screen, wait two minutes before logging into
the Prestige again.
262
for upgrading firmware using FTP/TFTP commands.
DESCRIPTION
Type in the location of the file you want to upload in this field or click Browse ... to find it.
Click Browse... to find the .bin file you want to upload. Remember that you must
decompress compressed (.zip) files before you can upload them.
Click Upload to begin the upload process. This process may take up to two minutes.
Click this button to clear all user-entered configuration information and return the
Prestige to its factory defaults. Refer to the Resetting the Prestige section.
Chapter 21 Maintenance