Prestige 2602HW Series User's Guide
Table 126 General Commands for GUI-based TFTP Clients
COMMAND DESCRIPTION
Host
Send/Fetch
Local File
Remote File This is the filename on the Prestige. The filename for the firmware is "ras" and for the
Binary
Abort
Refer to
Section 37.2.5 on page 368
over WAN.
37.2.9 Backup Via Console Port
Back up configuration via console port by following the HyperTerminal procedure shown
next. Procedures using other serial communications programs should be similar.
1 Display menu 24.5 and enter "y" at the following screen.
Figure 221 System Maintenance: Backup Configuration
2 The following screen indicates that the Xmodem download has started.
Figure 222 System Maintenance: Starting Xmodem Download Screen
3 Run the HyperTerminal program by clicking Transfer, then Receive File as shown in the
following screen.
370
Enter the IP address of the Prestige. 192.168.1.1 is the Prestige's default IP address
when shipped.
Use "Send" to upload the file to the Prestige and "Fetch" to back up the file on your
computer.
Enter the path and name of the firmware file (*.bin extension) or configuration file (*.rom
extension) on your computer.
configuration file, is "rom-0".
Transfer the file in binary mode.
Stop transfer of the file.
to read about configurations that disallow TFTP and FTP
Ready to backup Configuration via Xmodem.
Do you want to continue (y/n):
You can enter ctrl-x to terminate operation any
time.
Starting XMODEM download...
Chapter 37 Firmware and Configuration File Maintenance