Table of Contents
Advertisement
6.11.6
Assembling the tap compression
Info
The procedures are the same on both fork legs.
–
Check the outer tube for damage.
»
If damage is found:
–
Change the outer tube.
B03584-10
–
Check the surface of the sliding bushings.
»
When bronze-colored layer
ing layer
–
Change the guiding bushes.
200665-10
–
Check the spring length.
Guideline
Spring length with preload
spacer(s)
»
If the measured value is greater than the specified value:
–
Reduce the thickness of the preload spacers.
»
If the measured value is less than the specified value:
–
Increase the thickness of the preload spacers.
B04555-10
–
Mount the tap compression on a suitable hexagon socket and
clamp into a vise.
–
Mount O-ring
–
Grease O-ring.
Lubricant (T158) (
–
Mount shim stack
Info
B04508-10
Mount the smaller shims below.
FORK, TRIPLE CLAMP 6
A
becomes visible under glid-
B
:
474 mm (18.66 in)
Info
There may only be one preload spacer installed,
or none at all.
1
.
p. 360)
2
.
51
Advertisement
Table of Contents
