Table of Contents
Advertisement
6 FORK, TRIPLE CLAMP
6.10.6
28
B03584-10
200665-10
B04555-10
Assembling the tap compression
Info
The procedures are the same on both fork legs.
B04508-10
–
Check the outer tube for damage.
»
If damage is found:
–
Change the outer tube.
–
Check the surface of the sliding bushings.
»
When the bronze-colored layer
B
the gliding layer
:
–
Change the sliding bushings.
–
Check the spring length.
Guideline
Spring length with preload
spacer(s)
»
If the measured value is greater than the specified value:
–
Reduce the thickness of the preload spacers.
»
If the measured value is less than the specified value:
–
Increase the thickness of the preload spacers.
Info
There may only be one preload spacer installed,
or none at all.
–
Mount the tap compression on a suitable hexagon socket and
clamp into a vise.
–
1
Mount O-ring
.
–
Grease O-ring.
Lubricant (T158) (
p. 360)
–
2
Mount shim stack
.
Info
Mount the smaller shims below.
A
becomes visible under
474 mm (18.66 in)
Advertisement
Table of Contents
