Pto Shaft; Residual Risk - SaMASZ UNO 410 Operator's Manual

Tab. 3. Location of centre of gravity
Dimension [mm]
A
B
4.3. Operating parts
Prior to operating the rakes check the rotor and the tine condition.

Worn or damaged tines should be replaced immediately with new ones.


4.4. PTO shaft

Before operating learn provisions found in bar manufacturer's manual placed on the bar.

Use only the rake's manufacturer recommended PTO shafts.

In order to operate safely use only fully technically fit, undamaged PTO shafts. Damaged PTO

shaft shall be repaired or replaced with new one.
Before any operation make sure whether PTO rpm have proper rotational direction.


4.5. Residual risk

Despite the fact, that SaMASZ company – the manufacturer of the rake takes the
responsibility for the rakes design and manufacturing, in order to eliminate hazard, certain risk
when operating the machine is unavoidable.
4.5.1. Danger of catching
This kind of risk occurs when the rake's position is changed, when operating near rotating
parts, operating without safety guards.
When operating, maintenance and regulation works are conducted always wear protective
gloves, footwear and clothing with no loose parts, belts, etc. Always comply with safety decals
placed on the rake.
4.5.2. Danger of wound
This kind of risk appears when operating parts with sharp edges are replaced. For any repair
and maintenance works always wear safety gloves.
NOTE:
Residual risk results from incorrect behaviour of the machine's operator.
4.5.3. Bans
Bear in mind the following bans when operating the rakes:
Do not unblock the rake, make any adjustments or repairs when the mower is operating.

Never change the sequence of operation and maintenance works specified in the operator's

manual.
Never operate the rake when its working condition is poor or has safety guards damaged.

Never get your limbs close to rake's rotating parts.

During the rake's repair and maintenance works always comply with the descriptions included

in the operator's manual, while conducting them with the tractor drive disconnected.
Prior to approaching any works, focus your attention solely on the tasks to do.

Operator's manual
Uno 410
70
2700
- 8 -
Rotary rake UNO
Model
Uno 440
100
2760
Uno 470
70
3050