Working Parts; Pto Shaft; Hydraulic Assembly - SaMASZ KDT 220 Operator's Manual

OPERATOR'S MANUAL REAR DISC MOWER
Tab. 4. Location of centre of gravity
Dimension
[mm] KDT 180 KDT 220
A 2' 5" 2' 4"
B 5" 1"
C 2' 9" 3' 2"

4.5. Working parts

Before operating the mower check knife's and knife holder's condition.
❑
Worn or damaged knives or knife holders should be immediately replaced with new one.
❑
During replacement of working parts, it should be used personal protective gloves.
❑

4.6. PTO shaft

Before operating, read bar manufacturer's manual placed on the bar. Follow all safety precautions
❑
in that manual.
Use only PTO shafts recommended by mower's manufacturer with guards in good condition.
❑
In order to operate safely, use only undamaged PTO shafts and shields. Damaged PTO shafts and
❑
shields must be repaired or replaced with new ones before use.
Before any operation make sure whether PTO rpm have proper rotational direction.
❑

4.7. Hydraulic assembly

Hydraulic assembly is under high pressure. Hydraulic oil under pressure may penetrate skin and
❑
cause serious injury or death. Skin and eyes should be protected when working around this
assembly.
In case of injury caused by a liquid under pressure, call a doctor immediately.
❑
Hydraulic hoses can be connected to the tractor's hydraulics provided that both the tractor's and
❑
the mower's hydraulic assemblies are not under pressure. To remove the pressure from the hoses,
start the tractor's hydraulic valves several times with the tractor off.
When looking for oil leaks, do so safely. Use a cardboard card. Do not touch any potential leaks
❑
until the entire hydraulic assembly has been relieved of pressure.
KDT
Fig. 6. Location of centre of gravity on mowers KDT
KDT 220 KDT 220
KDT 260
S W
2' 9" 2' 9" 2' 8"
4" 5.5" 6.3"
3' 4" 3' 6" 3' 4"
Model
KDT 260 KDT KDT 260
S 260 SL W
2' 8" 2' 8" 2' 9"
8" 8.7" 8.7"
3' 5" 3' 4" 3' 7"
KDT 300 KDT 340 KDT 341
2' 4" 2' 4"
1' 1' 7"
3' 5" 3'7"
15