Solenoid Valve Assembly - Mile Marker H Series Installation And Operator's Manual

SOLENOID VALVE ASSEMBLY

The Mile Marker solenoid valve should be mounted away from any areas where heat may be considered too extreme such as an exhaust man-
ifold or turbo. Be sure all plumbing and wiring reaches from the area selected without being stressed. The Mile Marker solenoid valve may be
mounted by using the bracket and alien screws supplied. Using the bracket as a guide, mark the location of where the mounting holes are going
to be drilled and remove the plate and drill two 2¼/ holes. Mount valve assembly using nuts, bolts and washers supplied. Your solenoid valve
comes with a flow disc. Make sure you install it in the right port. See (Fig. 1).
NOTE: On some vehicles the grill may have to be removed to install plumbing and wiring for the winch.
Figure 1
Page 7