COBHAM EXPLORER 6075LX User & Installation Manual page 3

The following general safety precautions must be observed during all phases of operation,
service and repair of this equipment. Failure to comply with these precautions or with specific
warnings elsewhere in this manual violates safety standards of design, manufacture and
intended use of the equipment. Thrane & Thrane A/S assumes no liability for the customer's
failure to comply with these requirements.
This equipment is not suitable for use in locations where children are likely to be
present.
Power supply
The voltage range for the EXPLORER 6075LX is 24-48 VDC nominal. We recommend to use the
EXPLORER 6000 Series power Supply (403160P) from Cobham SATCOM
WARNING! Before disassembling or performing any maintenance or upgrades,
unplug the unit from the power source.
When you use a transportable and/or temporary power supply, e.g. a generator, refer
Note
to the national legislation for correct safety ground connection.
Do not operate in an explosive atmosphere
Do not operate the equipment in the presence of flammable gases or fumes. Operation of any
electrical equipment in such an environment constitutes a definite safety hazard.
Keep away from live circuits
Operating personnel must not remove equipment covers. Component replacement and internal
adjustment must be made by qualified maintenance personnel. Do not replace components
with the power cable connected. Under certain conditions, dangerous voltages may exist even
with the power cable removed. To avoid injuries, always disconnect power and discharge
circuits before touching them.
WARNING! Be aware of pinch points while the antenna is being positioned,
deployed or stowed.
Service
User access to the interior of the antenna is not allowed. Only a technician authorized by
Cobham SATCOM may perform service - failure to comply with this rule will void the warranty.
98-165591-B
Safety summary
iii