Grundfos CIM 200 Functional Profile And User Manual page 57

Code Description
211 Low pressure
Diaphragm tank precharge
212
pressure out of range
213 VFD not ready
214 Water shortage, level 2
215 Soft pressure buildup time-out
216 Pilot pump alarm
Alarm, general-purpose sensor
217
high
218 Alarm, general-purpose sensor low
219 Pressure relief not adequate
220 Fault, motor contactor feedback
221 Fault, mixer contactor feedback
222 Time for service, mixer
223 Time for service, mixer
Pump fault, due to auxiliary
224
component or general fault
Communication fault, pump
225
module
Code Description
226 Communication fault, I/O module
227 Combi event
228 Night flow max. limit exceeded
229 Water on floor
230 Network alarm
Ethernet: No IP address from
231
DHCP server
Ethernet: Auto-disabled due to
232
misuse
233 Ethernet: IP address conflict
234 Backup pump alarm
235 Gas detected
236 Pump 1 fault
237 Pump 2 fault
238 Pump 3 fault
239 Pump 4 fault
Lubricate bearings (specific
240
service information)
Code Description
241 Motor phase failure
Automatic motor model recognition
242
failed
Motor relay has been forced
243 (manually operated or
commanded)
244 Fault, On/Off/Auto switch
245 Pump continuous runtime too long
User-defined relay has been
246 forced (manually operated or
commanded)
Power-on notice, (device or
247
system has been switched off)
248 Fault, battery/UPS
249 User-defined event 1
250 User-defined event 2
251 User-defined event 3
252 User-defined event 4
SMS data from DDD sensor not
253
received within time limit
254 Inconsistent data model
57