Status Leds - Grundfos CIM 200 Functional Profile And User Manual

6.1.3 Connecting the battery and power supply
WARNING
Electric shock
Death or serious personal injury
- Connect CIM 260 only to SELV or SELV-E circuits.
WARNING
Flammable material
Death or serious personal injury
- The safety precautions listed below must be
observed carefully as improper handling of the
lithium-ion battery may result in injury or damage
from electrolyte leakage, heating ignition or
explosion.
• Only insert the approved Grundfos battery pack (99499908).
• Never use this battery pack in other battery chargers.
• Do not dismantle or modify the battery.
• Do not heat or incinerate the battery.
• Do not pierce, crush or cause mechanical damage to the
battery.
• Do not short-circuit the battery.
• Do not allow the battery to get wet or be immersed in water.
• Do not strike or throw the battery.
• For long periods of storage, the temperature must be below 35
°C.
You can fit CIM 260 with a lithium-ion battery (order no.
99499908), which will ensure sustained cellular connection with
the product in which it is mounted, even if the power is switched
off. The battery is secured by a velcro strap which absorbs
vibrations and simplifies replacement. Connect the battery to CIM
260 as shown in fig. 15.
If a battery is not connected, the user will not receive
any information in case of a power cut.
Fig. 15 Connecting the battery
You can only charge the battery if the battery
temperature is within 0 to 45 °C.
Switch on the power supply. CIM 260 is powered either by the
Grundfos product or by the battery.
LED1 flashes yellow, searching for a cellular network. When the
connection to the cellular network has been established, LED1
pulsates yellow, the cellular network is active. See fig. 16.
LED2 is permanently green, indicating that you have fitted CIM
260 correctly in the Grundfos product.
6.1.4 Configuration
For software configuration of CIM 260, which includes setting of
SMS functions and SCADA communication parameters, see "CIM
260 SMS commands", which you can download from Grundfos
Product Center.

6.2 Status LEDs

The CIM 260 module has two LEDs. See fig. 12.
• Yellow and green status LED1 for cellular communication.
• Red and green status LED2 for internal communication
between CIM 260 and the Grundfos product.
LED1, yellow and green
1
2
3
4
1 second
3 seconds
Yellow Green
Fig. 16 LED1 status
Pos. Status
1 Flashing yellow
Pulsating yellow,
2
single pulse
Pulsating green,
3
single pulse
4 Green, 3 seconds
LED2, red and green
Status Description
Off CIM 260 has been switched off.
No communication between CIM 260 and
Flashing red
the Grundfos product.
CIM 260 does not support the connected
Permanently red
version of the Grundfos product.
Permanently The connection between CIM 260 and the
green Grundfos product is OK.
Description
Searching for cellular network.
Connection to the cellular
network has been established.
Communication via data
connection.
Sending or receiving an SMS
message.
13