Appendix; Error Messages - Rice Lake Legend 480 Series Operation Manual

480 Legend Series Digital Weight Indicator
3.0

Appendix

3.1

Error Messages

The 480 provides a number of front panel error messages to assist in problem diagnosis.
Table 3-1 lists these messages and their meanings.
Error
Message
E A/D A/D physical error
EEEROM EEPROM physical error
EVIREE Virgin EEPROM
EPCKSM Parameter checksum error
EACKSM A/D calibration checksum
error
EFCKSM Printer format checksum error Call Rice Lake Weighing Systems Service at
ELCKSM Load cell calibration
checksum error
EIDATA Internal RAM checksum error Call Rice Lake Weighing Systems Service at
E REF A/D reference error
ERROR Internal program error
OVERFL Overflow error
- - - - - - Gross > overload limit
- - - - - -
- - - - - -
Gross < 20d behind zero
- - - - - -
RNGERR GRADS > 100,000
WVAL > 100,000
EEPERR EEPROM error
HINOFF? High offset
20 Visit our website
Description
Table 3-1. 480 Error Messages
www.RiceLake.com
Solution
Call Rice Lake Weighing Systems (Rice Lake
Weighing Systems) Service at 800-472-6703.
Use TEST menu to perform DEFLT (restore
defaults) procedure, then recalibrate load cells.
A/D converter requires recalibration.
Call Rice Lake Weighing Systems Service.
800-472-6703.
Recalibrate load cells.
800-472-6703.
A/D converter requires recalibration.
Call Rice Lake Weighing Systems Service.
Check configuration.
Call Rice Lake Weighing Systems Service if unable
to clear error by cycling power or if error recurs.
Weight value too large to be displayed.
Gross value exceeds overload limit. Check
configuration or signal input level. Overload can be
caused by input signal > 45 mV or common mode
voltage > 950 mV.
Gross value is more than 20 divisions behind zero.
Only shows up in Config mode.
Call Rice Lake Weighing Systems for service at
800-472-6703.
Zero load at powerup is more than initial zero
range (INIZR) setting of calibration zero – remove
the extra load.