Operation - YILMAZ SC 550P User Manual

7.2 Operation

When the machine is opened from the Main Switch (FIGURE 3 NO 9) or the Emergency Stop button is
pressed, any one of the degree selection buttons shown in the FIGURE 13 should be presse done time
for the machine to come to reference
7.2.1 Place material that you are going to process on to the table Fix it with clamps (FIGURE 6 NO.12) on the table.
7.2.2 The cutting direction angles of heads are determined with the Degree selection button seen in the FIGURE 13.
When button is taken to which direction position (internal angle or external angle), the head will go that angle in
that direction.
7.2.3 Whichever head angle is adjusted to adjust the internal side angle it is put firstly towards external side angle.
The fastening pipe in the internal side are loosens and the safety catch is pulled backward and after it is brought
to the desired angle and then left, the safety catch is also left. Finally the fastening pipe is tightened again and
the adjustment of the internal side is completed.
7.2.4 Whichever head angle is adjusted to adjust the external side angle it is put firstly towards internal side angle.
The article 7.2.5 is
7.2.5 Bring the ''Degree adjustment stop'' to the desired angle value and tighten the fastening pipe on it (see
FIGURE 7 NO 15). If the angle value of the part to be cut is one of the 15-22.5-30-45-90 degrees, be sure that
the ''safety catch axle '' runs to the hole slot in the channel. If the cutting action will be made in the space
degrees except of the above mentioned degreese, there is no hole against the safety catch axle. It will be
enough only to tighten the screws on the degree adjustment stop. After making these actions the button on that
direction, from the degree selection buttons seen in the FIGURE 13, is pressed depending on the angle in sides
of internal and external and the head is put in the desired angle. Furthermore, in any case the head is adjusted
in any angle, when pressing 90 degree button, it comes to 90 degree automatically and without any adjustment.
applied..
44